Dependable NSE7_EFW-7.0 Exam Dumps to Become Fortinet Certified

Get Ready with NSE7_EFW-7.0 Exam Dumps (2024)

NEW QUESTION # 40
Refer to the exhibit, which contains the partial output of a diagnose command.

Based on the output, which two statements are correct? (Choose two.)

• A. Remote gateway IP is 10.200.4.1.
• B. Quick mode selectors are disabled.
• C. Anti-replay is enabled.
• D. DPD is disabled.

Answer: A,C

NEW QUESTION # 41
A FortiGate device has the following LDAP configuration:

The LDAP user student cannot authenticate. The exhibit shows the output of the authentication real time debug while testing the student account:

Based on the above output, what FortiGate LDAP settings must the administer check? (Choose two.)

• A. password.
• B. dn.
• C. username.
• D. cnid.

Answer: A,C

Explanation:
https://kb.fortinet.com/kb/viewContent.do?externalId=13141

NEW QUESTION # 42
View the exhibit, which contains the output of a BGP debug command, and then answer the question below.

Which of the following statements about the exhibit are true? (Choose two.)

• A. The local BGP peer has not established a TCP session to the BGP peer 10.200.3.1.
• B. The local BGP peer has received a total of three BGP prefixes.
• C. For the peer 10.125.0.60, the BGP state of is Established.
• D. Since the BGP counters were last reset, the BGP peer 10.200.3.1 has never been down.

Answer: A,C

NEW QUESTION # 43
View the exhibit, which contains the output of get sys ha status, and then answer the question below.

Which statements are correct regarding the output? (Choose two.)

• A. The HA management IP is 169.254.0.2.
• B. port 7 is used the HA heartbeat on all devices in the cluster.
• C. Master is selected because it is the only device in the cluster.
• D. The slave configuration is not synchronized with the master.

Answer: B,D

NEW QUESTION # 44
Examine the output from the 'diagnose vpn tunnel list' command shown in the exhibit; then answer the question below.

Which command can be used to sniffer the ESP traffic for the VPN DialUP_0?

• A. diagnose sniffer packet any 'esp'
• B. diagnose sniffer packet any 'host 10.0.10.10'
• C. diagnose sniffer packet any 'port 500'
• D. diagnose sniffer packet any 'port 4500'

Answer: D

NEW QUESTION # 45
View the exhibit, which contains the output of a real-time debug, Which statement about this output is true?

Which of the following statements is true regarding this output?

• A. The server hostname Is training, fortinet.com.
• B. The requested URL belongs to category ID 255.
• C. This web request was inspected using the ftgd-allow web filler profile.
• D. FortiGate found the requested URL in its local cache.

Answer: D

Explanation:
Example log for no local cache case: #id=93000 msg="pid=57 urlfilter_main-723 in main.c received pkt:count=91 "IPS and WAD will only send request to urlfilter daemon when cache is missed. " So the WAD process by itself found the URL rating in the local cache and didn`t ask for help from the URL process as in the example.

NEW QUESTION # 46
When using the SSL certificate inspection method for HTTPS traffic, how does FortiGate filter web requests when the browser client does not provide the server name indication (SNI) extension?

• A. FortiGate uses the requested URL from the user's web browser.
• B. FortiGate uses CN information from the Subject field in the server's certificate.
• C. FortiGate switches to the full SSL inspection method to decrypt the data.
• D. FortiGate blocks the request without any further inspection.

Answer: B

NEW QUESTION # 47
A FortiGate is configured as an explicit web proxy. Clients using this web proxy are reposting DNS errors when accessing any website. The administrator executes the following debug commands and observes that the n-dns-timeout counter is increasing:

What should the administrator check to fix the problem?

• A. The connectivity between the FortiGate unit and the DNS server.
• B. That DNS traffic from client workstations is allowed by the explicit web proxy policies.
• C. That DNS service is enabled in the explicit web proxy interface.
• D. The connectivity between the client workstations and the DNS server.

Answer: A

NEW QUESTION # 48
How are bulk configuration changes made using FortiManager CLI scripts? (Choose two.)

• A. When run on the Policy Package, ADOM database, you must use the installation wizard to apply the changes to the managed FortiGate device
• B. When run on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.
• C. When run on the All FortiGate in ADOM, changes are automatically installed without the creation of a new revision history.
• D. When run on the Device Database, changes are applied directly to the managed FortiGate device.

Answer: A,B

Explanation:
CLI scripts can be run in three different ways: Device Database: By default, a script is executed on the device database. It is recommend you run the changes on the device database (default setting), as this allows you to check what configuration changes you will send to the managed device. Once scripts are run on the device database, you can install these changes to a managed device using the installation wizard.
Policy Package, ADOM database: If a script contains changes related to ADOM level objects and policies, you can change the default selection to run on Policy Package, ADOM database and can then be installed using the installation wizard.
Remote FortiGate directly (through CLI): A script can be executed directly on the device and you don't need to install these changes using the installation wizard. As the changes are directly installed on the managed device, no option is provided to verify and check the configuration changes through FortiManager prior to executing it.

NEW QUESTION # 49
Refer to the exhibit, which contains the partial output of a diagnose command.

Based on the output, which two statements are correct? (Choose two.)

• A. Anti-replay is enabled
• B. Quick mode selectors are disabled.
• C. The remote gateway IP is 10.200.4.1.
• D. DPD is disabled.

Answer: A,C

NEW QUESTION # 50
View the central management configuration shown in the exhibit, and then answer the question below.

Which server will FortiGate choose for antivirus and IPS updates if 10.0.1.243 is experiencing an outage?

• A. 10.0.1.244
• B. One of the public FortiGuard distribution servers
• C. 10.0.1.242
• D. 10.0.1.240

Answer: B

NEW QUESTION # 51
Which two statements about OCVPN are true? (Choose two.)

• A. OCVPN supports static and dynamic IPs in WAN interface.
• B. Only root vdom supports OCVPN.
• C. FortiGate devices under different FortiCare accounts can be used to form OCVPN.
• D. OCVPN offers only Hub-Spoke VPNs.

Answer: A,B

NEW QUESTION # 52
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.

Why didn't the tunnel come up?

• A. The remote gateway's phase 2 configuration does not match the local gateway's phase 2 configuration.
• B. The pre-shared keys do not match.
• C. The remote gateway's phase 1 configuration does not match the local gateway's phase 1 configuration.
• D. The remote gateway is using aggressive mode and the local gateway is configured to use man mode.

Answer: C

NEW QUESTION # 53
Refer to the exhibit, which contains the output of diagnose sys session list.

If the HA ID for the primary unit is zero (0), which statement about the output is true?

• A. The master unit is processing this traffic.
• B. The inspection of this session has been offloaded to the slave unit.
• C. This session cannot be synced with the slave unit.
• D. This session is for HA heartbeat traffic.

Answer: A

NEW QUESTION # 54
View the exhibit, which contains the output of a diagnose command, and then answer the question below.

What statements are correct regarding the output? (Choose two.)

• A. Traffic in the original direction (coming from the IP address 10.171.122.38) will be routed to the next-hop IP address 10.0.1.10.
• B. This is an expected session created by a session helper.
• C. This is an expected session created by an application control profile.
• D. Traffic in the original direction (coming from the IP address 10.171.122.38) will be routed to the next-hop IP address 10.200.1.1.

Answer: B,D

NEW QUESTION # 55
View the following FortiGate configuration.

All traffic to the Internet currently egresses from port1. The exhibit shows partial session information for Internet traffic from a user on the internal network:

If the priority on route ID 1 were changed from 5 to 20, what would happen to traffic matching that user's session?

• A. The session would remain in the session table, but its traffic would now egress from both port1 and port2.
• B. The session would be deleted, so the client would need to start a new session.
• C. The session would remain in the session table, and its traffic would start to egress from port2.
• D. The session would remain in the session table, and its traffic would still egress from port1.

Answer: D

Explanation:
http://kb.fortinet.com/kb/documentLink.do?externalID=FD40943

NEW QUESTION # 56
Which two configuration commands change the default behavior for content-inspected traffic while FortiGate is in conserve mode? (Choose two.)

• A. set ips fail-open disable
• B. set fail-open enable
• C. set av-failopen off
• D. set av-failopen pass

Answer: B,C

Explanation:
https://docs.fortinet.com/document/fortigate/7.2.4/administration-guide/194558/conserve-mode

NEW QUESTION # 57
Refer to exhibit, which contains the output of a BGP debug command.

Which statement explains why the state of the 10.200.3.1 peer is Connect?

• A. The TCP session to 10.200.3.1 has not completed the 3-way handshake.
• B. The local router has received the BGP prefixes from the remote peer.
• C. The local router is receiving the BGP keepalives from the peer, but it has not received a BGP prefix yet.
• D. The local router is receiving BGP keepalives from the remote peer, but the local peer has not received the OpenConfirm yet.

Answer: A

NEW QUESTION # 58
......

Fortinet NSE7_EFW-7.0 Certification Exam is designed for professionals who want to showcase their expertise in enterprise-level firewall technologies. Fortinet NSE 7 - Enterprise Firewall 7.0 certification exam is part of the Fortinet NSE 7 certification program and is designed to validate your skills in deploying, configuring, and managing Fortinet Enterprise Firewalls in a real-world environment. Fortinet NSE 7 - Enterprise Firewall 7.0 certification exam covers a range of topics including network security, Fortinet firewall technologies, and advanced threat protection.

 

Download Exam NSE7_EFW-7.0 Practice Test Questions with 100% Verified Answers: https://pass4sure.examstorrent.com/NSE7_EFW-7.0-exam-dumps-torrent.html